HP AP775A Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Release 4.1( - Page 11
Migrating from Supervisor-1 Modules to Supervisor-2 Modules, Software Download Process
UPC - 884962062708
View all HP AP775A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Migrating from Supervisor-1 Modules to Supervisor-2 Modules Send documentation comments to mdsfeedback-doc.com. Table 5 Module Support Matrix for Cisco MDS SAN-OS 3.x (continued) Module DS-X9308-SMIP DS-X9304-SMIP Description 8-port 1-, 2-Gbps IP Switching Module 4-port 1-, 2-Gbps IP Switching Module MDS 9500 Series Yes Yes MDS 9222i No Yes MDS 9216i Yes Yes MDS 9216A Yes Yes MDS 9216 Yes Yes Migrating from Supervisor-1 Modules to Supervisor-2 Modules As of Cisco MDS SAN-OS Release 3.0(1), the Cisco MDS 9509 and 9506 Directors support both Supervisor-1 and Supervisor-2 modules. Supervisor-1 and Supervisor-2 modules cannot be installed in the same switch, except during migration. Both the active and standby supervisor modules must be of the same type, either Supervisor-1 or Supervisor-2 modules. For Cisco MDS 9513 Directors, both supervisor modules must be Supervisor-2 modules. Caution Migrating your supervisor modules is a disruptive operation. Note Migrating from Supervisor-2 modules to Supervisor-1 modules is not supported. To migrate from a Supervisor-1 module to a Supervisor-2 module, refer to the step-by-step instructions in the Cisco MDS 9000 Family Software Upgrade and Downgrade Guide. Software Download Process Use the software download procedure to upgrade to a later version, or downgrade to an earlier version, of an operating system. This section describes the software download process for the Cisco MDS NX-OS software and includes the following topics: • Determining the Software Version, page 11 • Downloading Software, page 12 • Selecting the Correct Software Image for an MDS 9100 Series Switch, page 13 • Selecting the Correct Software Image for an MDS 9200 Series Switch, page 13 • Selecting the Correct Software Image for an MDS 9500 Series Switch, page 13 Determining the Software Version To determine the version of Cisco MDS NX-OS or SAN-OS software currently running on a Cisco MDS 9000 Family switch using the CLI, log in to the switch and enter the show version EXEC command. To determine the version of Cisco MDS NX-OS or SAN-OS software currently running on a Cisco MDS 9000 Family switch using the Fabric Manager, view the Switches tab in the Information pane, locate the switch using the IP address, logical name, or WWN, and check its version in the Release column. OL-17675-05 Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Release 4.1(3a) 11