HP BL680c ProLiant BL680c Generation 5 Processor Option Installation Instructi
HP BL680c - ProLiant - G5 Manual
 |
UPC - 884420396314
View all HP BL680c manuals
Add to My Manuals
Save this manual to your list of manuals |
HP BL680c manual content summary:
- HP BL680c | ProLiant BL680c Generation 5 Processor Option Installation Instructi - Page 1
Processor Option Installation Instructions for HP ProLiant BL680c Generation 5 Server Blades © Copyright 2007 Hewlett-Packard Development Company, L.P. The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express - HP BL680c | ProLiant BL680c Generation 5 Processor Option Installation Instructi - Page 2
designed to fit one way into the socket. Use the alignment guides on the processor and socket to properly align the processor with the socket. 7. Install the processor. 11. Install the access panel. 12. Install the server blade. The installation is complete. 8. Close the processor locking lever.
-
1 -
2
 |
 |
Processor Option
Installation Instructions
for HP ProLiant BL680c Generation 5 Server Blades
Kit contents
•
Processor
•
Heatsink
•
This document
Processor installation
WARNING:
To reduce the risk of personal injury
from hot surfaces, allow the drives and the internal
system components to cool before touching them.
CAUTION:
To avoid damage to the system board:
•
Do not touch the processor socket contacts.
•
Do not tilt or slide the processor when lowering
the processor into the socket.
CAUTION:
To avoid damage to the processor:
•
Handle the processor only by the edges.
•
Do not touch the bottom of the processor,
especially the contact area.
CAUTION:
To prevent possible server malfunction
and damage to the equipment, multiprocessor
configurations must contain processors with the same
part number.
CAUTION:
To prevent possible server blade
overheating, always populate processor sockets with
a processor and a heatsink or a heatsink blank.
CAUTION:
The heatsink thermal interface media is
not reusable and must be replaced if the heatsink is
removed from the processor after it has been
installed.
IMPORTANT:
When installing the heatsink, align the
guide pin on the processor retention bracket with the
alignment holes in the heatsink.
IMPORTANT:
Processor socket 1 must always be
populated. If processor socket 1 is empty, the server
blade does not power up.
To install a processor:
1.
Power down the server blade.
2.
Remove the server blade.
3.
Place the server blade on a flat, level work surface.
4.
Remove the access panel.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
The information contained herein is subject to change without notice. The
only warranties for HP products and services are set forth in the express
warranty statements accompanying such products and services. Nothing
herein should be construed as constituting an additional warranty. HP shall
not be liable for technical or editorial errors or omissions contained herein.
Part Number 452660-001
September 2007 (First Edition)