HP C8907A HP Photosmart R-series dock - User Manual - Page 17

Technical Support, Troubleshooting

Page 17 highlights

Technical Support Please refer to your camera User's Manual for support procedures and contact information. Troubleshooting NOTE For additional troubleshooting information, please see the Troubleshooting section in your camera User's Manual. Problem Possible cause Solution The camera Batteries in the Install a rechargeable lithium ion batteries will camera are not battery. Disposable Duracell® CP-1 not charge, rechargeable. batteries are not rechargeable. and the camera charging light is on. The camera has not been left in the dock long enough. Make sure the camera has been left in the camera dock for at least 4 to 7 hours to charge completely, and the charging light has stopped blinking. Battery voltage The camera will not attempt to is too low for charge batteries that may be charging to damaged or over-discharged. start. Remove the battery from the camera and charge it in the dock recharging bay, then try it in the camera again. If the battery will not charge sufficiently in either the dock or the camera, it is likely that the battery is bad. Purchase a new lithium ion battery and try again. 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23

17
Technical Support
Please refer to your camera User’s Manual for support
procedures and contact information.
Troubleshooting
NOTE
For additional troubleshooting information, please see
the Troubleshooting section in your camera User°s
Manual.
Problem
Possible cause
Solution
The camera
batteries will
not charge,
and the
camera
charging
light is on.
Batteries in the
camera are not
rechargeable.
Install a rechargeable lithium ion
battery. Disposable Duracellfi CP-1
batteries are not rechargeable.
The camera
has not been
left in the dock
long enough.
Make sure the camera has been left
in the camera dock for at least
4 to 7 hours to charge completely,
and the charging light has stopped
blinking.
Battery voltage
is too low for
charging to
start.
The camera will not attempt to
charge batteries that may be
damaged or over-discharged.
Remove the battery from the
camera and charge it in the dock
recharging bay, then try it in the
camera again. If the battery will not
charge sufficiently in either the dock
or the camera, it is likely that the
battery is bad. Purchase a new
lithium ion battery and try again.