HP Cisco MDS 9124 HP StorageWorks C-Series Fabric Switches for SAN-OS 3.1(2a) - Page 11

switch(config)# exit 6. Copy the running configuration into the startup configuration by entering the following: switch# copy running-config startup-config Note: The running configuration overwrites the startup configuration. In the following example, port 9 is being set to 2-Gbps: switch login: admin password: switch# config terminal switch(config)# interface fc 1/9 switch(config-if)# switchport speed 2000 switch(config-if)# exit switch(config)# exit switch# copy running-config startup-config C-Series MDS 9124 Fabric Switch The MDS 9124 switches have fixed configurations with 8, 16, and 24 full rate 4-Gbps fibre channel ports. The 8 and 16 port switches can be upgraded in 8 port increments with a software expansion license. C-Series MDS 9124e Fabric Switch for HP c-Class BladeSystem The MDS 9124e 12-port fabric switch and the MDS 9124e 24-port fabric switch for HP c-Class BladeSystem have fixed configurations with 8-internal/4-external or 16-internal/8-external full rate 4-Gbps fibre channel ports. The 12-port switch can be upgraded to the 24-port switch with a software expansion license. Note: Refer to HP.com for the latest supported software for the QMH2462 HBA, LPe1105 HBA, and c-Class Onboard Administrator firmware. How to acquire a port license on the MDS 9124e 1. Log into the switch using either the management console or telnet 2. Enter your network-admin privileged account by entering your login name and password switch login: admin Password: 3. Enter the following command to verify which ports are eligible to receive a license: switch# show port-license 4. Enter into the configuration mode by entering the following command: switch# config terminal 5. Enter the following commands to enable a port license: 11 MDS Multilayer Director & Multilayer Fabric Switches Release Notes