HP Cisco MDS 9124 Cisco MDS 9000 Family CLI Configuration Guide, Release 3.x ( - Page 299

Chapter 11 Managing Modules Connecting to a Module Send documentation comments to [email protected] Table 11-3 Module States Module Status Output powered up testing initializing failure ok power-denied active HA-standby standby Description The hardware has electrical power. When the hardware is powered up, the software begins booting. The switching module has established connection with the supervisor module and the switching module is performing bootup diagnostics. The diagnostics have completed successfully and the configuration is being downloaded. The switch detects a switching module failure upon initialization and automatically attempts to power-cycle the module three times. After the third attempt it continues to display a failed state. The switch is ready to be configured. The switch detects insufficient power for a switching module to power up. This module is the active supervisor module and the switch is ready to be configured. The HA switchover mechanism is enabled on the standby supervisor module (see the "HA Switchover Characteristics" section on page 9-2). The warm switchover mechanism is enabled on the standby supervisor module (see the "HA Switchover Characteristics" section on page 9-2). Connecting to a Module At any time, you can connect to any module using the attach module command. Once you are at the module prompt, you can obtain further details about the module using module-specific commands in EXEC mode. OL-16184-01, Cisco MDS SAN-OS Release 3.x Cisco MDS 9000 Family CLI Configuration Guide 11-5