HP Cisco MDS 9140 Cisco MDS 9000 Family System Messages Reference (OL-15956-01 - Page 284

Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family Send documentation comments to [email protected] Error Message PORT-5-IF_DOWN_SRC_PORT_NOT_BOUND: Interface [chars] is down (Tunnel port src interface unbound). Explanation The FCIP link port source interface is not bound. Recommended Action No action is required. Introduced Cisco MDS SAN-OS Release 1.2(2a). Error Message PORT-5-IF_DOWN_SRC_PORT_REMOVED: Interface [chars] is down(Tunnel src port removed). Explanation The link source port of this FCIP interface has been removed. The source interface with the IP address that matches the IP address of the bound entity is removed. This happens normally because the module on which the source interface exists is removed. Recommended Action No action is required. Introduced Cisco MDS SAN-OS Release 1.2(2a). Error Message PORT-5-IF_DOWN_SUSPENDED: Interface [chars] is down (Suspended). Explanation This interface belongs to a PortChannel and has been suspended because of an error while bringing it up. Recommended Action In most cases, you can recover by entering the shutdown and no shutdown CLI commands or by using a similar Fabric Manager/Device Manager procedure. If this happens again, enter the show port internal all interface command or use a similar Fabric Manager procedure on the interface to gather more information. Introduced Cisco MDS SAN-OS Release 1.2(2a). Error Message PORT-5-IF_DOWN_SUSPENDED_BY_MODE: Interface [chars] is down (Suspended due to incompatible mode). Explanation This interface belongs to a PortChannel and the operational mode of the interface is different from that of the PortChannel. Recommended Action Change the mode and the trunking mode of the PortChannel from auto and check to ensure that the remote end of the interface also belongs to the same PortChannel. Introduced Cisco MDS SAN-OS Release 1.2(2a). Error Message PORT-5-IF_DOWN_SUSPENDED_BY_SPEED: Interface [chars] is down (Suspended due to incompatible speed). Explanation This interface belongs to a PortChannel and the operational speed of the interface is different from that of the PortChannel. Recommended Action Change the speed of the PortChannel from auto and check to ensure that the remote end of the interface also belongs to the same PortChannel. Introduced Cisco MDS SAN-OS Release 1.2(2a). 2-248 Cisco MDS 9000 Family System Messages Reference OL-15956-01