HP Cisco MDS 9216 Cisco MDS 9000 Family CLI Configuration Guide, Release 3.x ( - Page 477

Chapter 18 Scheduling Maintenance Jobs Execution Logs Send documentation comments to [email protected] Removing an Assigned Job To remove an assigned job, follow these steps: Step 1 Step 2 Step 3 Command switch# conf t switch(config)# switch(config)# scheduler schedule name weekendbackupqos switch(config-schedule)# switch(config-schedule)# no job name addMem99 Purpose Enters the configuration mode. Specifies a job schedule (weekendbackupqos) and enters the submode for that schedule. Removes a job (addMem99) assigned to this schedule. Deleting a Schedule Time To delete the schedule time, follow these steps: Step 1 Step 2 Step 3 Command switch# conf t switch(config)# switch(config)# scheduler schedule name weekendbackupqos switch(config-schedule)# switch(config-schedule)# no time Purpose Enters the configuration mode. Defines a job schedule (weekendbackup) and enters the submode for that schedule. Deletes the schedule time configuration.The schedule will not be run until the time is configured again. Verifying the Command Scheduler Execution Status To verify the command scheduler execution status, use the show scheduler schedule command. switch# show scheduler schedule configureVsan99 Schedule Name : configureVsan99 User Name : admin Schedule Type : Run once on Tue Aug 10 09:48:00 2004 Last Execution Time: Tue Aug 10 09:48:00 2004 Job Name Status addMemVsan99 Success (0) Execution Logs This section describes execution logs for the command scheduler and contains the following sections: • About Execution Logs, page 18-10 • Configuring Execution Logs, page 18-10 • Clearing the Execution Log File Contents, page 18-10 OL-16184-01, Cisco MDS SAN-OS Release 3.x Cisco MDS 9000 Family CLI Configuration Guide 18-9