HP Cisco MDS 9216A Cisco MDS 9000 Family CLI Configuration Guide, Release 3.x - Page 1375

Chapter 59 Monitoring System Processes and Logs Kernel Core Dumps Send documentation comments to [email protected] Configuring External Servers To configure the external server using IPv4, follow these steps: Step 1 Step 2 Command Purpose switch# config terminal switch(config)# Enters configuration mode. switch(config)# kernel core target 10.50.5.5 Configures the external server's IPv4 address. succeeded Note IPv6 addresses are not supported for kernel core targets. Configuring Module Parameters To configure the module parameters, follow these steps: Step 1 Step 2 Step 3 Command switch# config terminal switch(config)# switch(config)# kernel core module 5 succeeded switch(config)# kernel core module 5 level header succeeded switch(config)# kernel core limit 2 succeeded Purpose Enters configuration mode. Configures kernel core generation for module 5. Configures kernel core generation for module 5, and limits the generation to header-level cores. Configures kernel core generations for two modules. The default is 1 module. Displaying Kernel Core Information All changes made to the kernel cores may be viewed using the show running-config command. Alternatively, use the show kernel cores command to view specific configuration changes (see Example 59-17 to Example 59-19). Example 59-17 Displays the Core Limit switch# show kernel core limit 2 Example 59-18 Displays the External Server switch# show kernel core target 10.50.5.5 Example 59-19 Displays the Core Settings for the Specified Module switch# show kernel core module 5 module 5 core is enabled level is header dst_ip is 10.50.5.5 src_port is 6671 OL-16184-01, Cisco MDS SAN-OS Release 3.x Cisco MDS 9000 Family CLI Configuration Guide 59-11