HP Cisco Nexus 5000 HP StorageWorks C-Series Fabric Switches for SAN-OS 3.3(4a - Page 17

Note: Fabric/Device Manager cannot be used to configure this feature. 1. Log into the switch using either the management console or telnet. 2. Enter your network-admin privileged account by entering your login name and password switch login: admin Password: 3. Enter the following to enter configuration mode: switch# config terminal 4. Select the desired switch port: switch(config)# interface fc 1/ 5. Select the desired switch port speed: switch(config-if)# switchport speed ? 1000 1000 Mbps speed 2000 2000 Mbps speed 4000 4000 Mbps speed Auto Autosense speed switch(config-if)# switchport speed switch(config-if)# exit switch(config)# exit 6. Copy the running configuration into the startup configuration by entering the following: switch# copy running-config startup-config Note: The running configuration overwrites the startup configuration. In the following example, port 9 is being set to 2-Gbps: switch login: admin password: switch# config terminal switch(config)# interface fc 1/9 switch(config-if)# switchport speed 2000 switch(config-if)# exit switch(config)# exit switch# copy running-config startup-config C-SERIES MDS 9134 FABRIC SWITCH The MDS 9134 switch has a base 34-port chassis to accommodate up to 32 full rate 4-Gbps and 2 10-Gbps fibre channel ports. Four configurations are available:  24 4-Gbps active ports with optional 8-port 4-Gbps and 2-port 10-Gbps software expansion licenses  32 4-Gbps active ports with an optional 2-port 10-Gbps software expansion license  24 4-Gbps and 2 10-Gbps active ports; a 48-port stackable solution is available with the purchase of two of these products.  32 4-Gbps and 2 10-Gbps active ports; a 64-port stable solution is available with the purchase of two of these products. 17 MDS Multilayer Director & Multilayer Fabric Switches Release Notes