HP Designjet 10000s HP Designjet 10000s - Media Loading Guide - Page 1

HP Designjet 10000s Media Loading Guide Single side printing Dual side printing (Printing on the back of the media from the feed side after relocating from take-up side) Front side (without liner) Back Side (without liner) Not recommended Back Side (with liner) Recommended Dual roll printing (Main-Main) Mesh printing Suggested media path Front Panel mode Main scroll Tension Bar Sub scroll MAIN FRONT Depending on media (see media table) Depending on media (see media table) Not used Not used Take-up Setting Used to roll-up the media (optional) depending on media (see media table) Used to roll-up the media depending on media (see media table) Media Pressure Lever Depending on media (see media table) Depending on media (see media table) Carriage height Low if the media is thinner than 0.5 mm Low if the media is thinner than 0.5 mm Extra parts needed Vacuum None High None High Other comments None Two lines at the end of each plot will be printed. Banner P V C (S/A Vinyl) Textile Backlit Banner BACKm Depending on media (see media table) BACKm Depending on media (see media table) DUAL Use two tension bars (one for each slack) BACKm Depending on media (see media table) Main scroll Tension Bar ½ Media Width Shortest (16-inchs) ½ Media Width ½ Media Width Not used Not used Used to roll-up the media (not recommended) Used to roll-up the liner. Media Width Bar/Small Flanges/2xO-Rings Depending on media (see media table) Depending on media (see media table) Low if the media is thinner than 0.5 mm None High High Special edge guard hook, Wiper side edge guard, Cap side edge guard, Attachment magnets (3) High Not used Used to roll-up the two media (optional) depending on media (See User Guide Chapter 3) Depending on media (see media table) Low if the media is thinner than 0.5 mm Flange spacer (2) Flange joint Media edge guards (2) High Not used Used to roll-up the liner. Media Width Bar/Small Flanges/2xO-Rings Depending on media (see media table) Media Table Take-up Setting Media Width Bar / Small Flanges / 2xO-Rings Shortest Bar / Big Flanges Media Width Bar / Small Flanges / 2xO-Rings Media Width Bar / Big Flanges High Special edge guard hook, Wiper side edge guard, Cap side edge guard, Attachment magnets (3) High Media Pressure Lever Down (Normal) Down (Normal) Up (Low) Down (Normal) Rotate the image in the RIP before sending it. For alternative dual side methods see User Guide (Chapter 4). Rotate the image in the RIP by 180º before sending it. Set DETECT WIDTH to NONE Use the Separator bar. For alternative dual side methods see User Guide (Chapter 4). Maximum media roll width is 50". Use identical media rolls (type and width). The wound diameter on each roll must be the same. Only print on the outside of the media rolls. For alternative dual Roll methods see User Guide (Chapter 3). Set DETECT WIDTH to NONE. Use the Separator bar.