HP Designjet 111 HP Designjet 111 Printer Series - User Guide - Page 20

Change the network parameters - network card

Get HP Designjet 111 PDF manuals and user guides View all HP Designjet 111 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

Connect & install Change the network parameters Once the Jetdirect card has a valid IP address, changing the rest of the network parameters (or the IP address itself, if necessary) is very easy. You need only connect to the HP Jetdirect card's embedded Web server and configure the information in the Networking tab of the Web page. To connect to the card's embedded Web server, start your Web browser and, in the browser's address field, enter the IP address of the printer. Here you can change the parameters of each of the supported network protocols or, for example, view network statistics or set an administrator password. In the Home tab, among other information, you can see the device to which the Jetdirect card is connected and the hardware address. If you need to change the IP parameters, the first step must always be to change the IP configuration method from BOOTP or DHCP to Manual. If the screen you see is not in your preferred language, click Select Language on the left-hand side of the page. 14 Chapter 2 Connection and software installation ENWW

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
Change the network parameters
Once the Jetdirect card has a valid IP address, changing the rest of the network parameters (or the IP
address itself, if necessary) is very easy. You need only connect to the HP Jetdirect card's embedded
Web server and configure the information in the
Networking
tab of the Web page. To connect to the
card's embedded Web server, start your Web browser and, in the browser's address field, enter the
IP address of the printer.
Here you can change the parameters of each of the supported network protocols or, for example,
view network statistics or set an administrator password. In the
Home
tab, among other information,
you can see the device to which the Jetdirect card is connected and the hardware address.
If you need to change the IP parameters, the first step must always be to change the IP configuration
method from BOOTP or DHCP to Manual.
If the screen you see is not in your preferred language, click
Select Language
on the left-hand side
of the page.
14
Chapter 2
Connection and software installation
ENWW
Connect & install