HP Designjet 2500/3500cp HP DesignJet 2500 and 2000CP Printer Quick Reference - Page 104
Sheet / Roll?
View all HP Designjet 2500/3500cp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 104 highlights
Sheet misaligned Reload sheet Sheet required for calibration Sheet / Roll? Reload media STATUS messages Switch power off Switch power off Check paper path Switch power off Check printhead path Sheet media is skewed. Remove it and reload it so that the left and right edges being loaded into the printer are square. The leading edge must also be straight. You have started an accuracy calibration check but media is not present. Load media. Either: Sheet mode was chosen while loading roll media. Reload media. Or: a sheet more than 51 inches (130 cm) long was loaded. Trim the sheet and reload. See pages 107 through 112. You have selected the transport mode shut-down sequence. The printer is waiting for you to turn the power switch, on the rear of the printer, to off. Switch off the printer. The printer may be jammed with media. Turn off the printer. Check the media path and clear it if necessary. Then turn on the printer. The printhead carriage cannot move. The printer may be jammed with media. Turn off the printer. Check the media path and clear it if necessary. Then turn on the printer. 104