HP Designjet T790 HP Designjet T1300/T790/T2300 Web Connected Features User's - Page 16

5 Internet connection Configure the Internet connection You can configure the product's Internet connection from the Embedded Web Server or from the front panel. NOTE: If an administrator password has been set, it will be required to change these settings. ● In the Embedded Web Server: select Setup > Internet connection. ● Using the front panel: press , then , then Connectivity > Internet connectivity. The following settings are available: ● Enable Internet connection: The default value is Yes. ● Proxy > Enable proxy: Enable or disable a proxy server. ● Proxy > Address: Enter the proxy address, empty by default. ● Proxy > Primary port: Enter the proxy port number, zero by default. ● Proxy > Restore factory settings: Return to the initial default settings. Internet communication failures If your product has difficulty in connecting to the Internet, it may start the Connectivity wizard automatically. You can also start the wizard manually at any time. ● From the Embedded Web Server: Select Support > Connectivity troubleshooting > Connectivity wizard. ● From the front panel: Press , then , then Connectivity > Connectivity wizard. ● From the front panel: Press , then , then Internal prints > Service information prints > Print connectivity config. In this case, the results are printed out. The wizard helps you to configure the Internet connection. Follow the instructions on the screen. 12 Chapter 5 Internet connection ENWW Internet