HP Dx2400 Service Reference Guide: HP Compaq dx2400 Business PC - Page 48
Computer Setup F10 Utility, on Connect external cables to the installed card
UPC - 884962251881
View all HP Dx2400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
8. To install a new expansion card, hold the card just above the expansion socket on the system board then move the card toward the rear of the chassis so that the bottom of the bracket on the card slides into the small slot on the chassis. Press the card straight down into the expansion socket on the system board. NOTE: When installing an expansion card, press firmly on the card so that the whole connector seats properly in the expansion card slot. 9. Replace the slot cover lock and secure it in place with the screw that was previously removed. 10. Connect external cables to the installed card, if needed. Connect internal cables to the system board, if needed. 11. Reconfigure the computer, if necessary. Refer to Computer Setup (F10) Utility on page 3 for instructions on using Computer Setup. 42 Chapter 6 Removal and Replacement Procedures Microtower (MT) Chassis