HP ENVY 17-2100 HP ENVY 17 - Maintenance and Service Guide - Page 70
Use the optical drive connector, until it rests at an
View all HP ENVY 17-2100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
2. Disconnect the subwoofer cable (1) and the power connector cable (2) from the system board. 3. Remove the two Phillips PM2.5×5.0 screws that secure the system board to the base enclosure. 4. Use the optical drive connector (1) to lift the right side of the system board (2) until it rests at an angle. 62 Chapter 4 Removal and replacement procedures ENWW
2.
Disconnect the subwoofer cable
(1)
and the power connector cable
(2)
from the system board.
3.
Remove the two Phillips PM2.5×5.0 screws that secure the system board to the base enclosure.
4.
Use the optical drive connector
(1)
to lift the right side of the system board
(2)
until it rests at an
angle.
62
Chapter 4
Removal and replacement procedures
ENWW