HP Evo Thin Client t20 Safety and Regulatory Information Desktops, Thin Client - Page 10
Compliance with International Regulations, Laser Product Label, Laser Information
View all HP Evo Thin Client t20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Compliance with International Regulations All systems equipped with CD-ROM drives comply with appropriate safety standards including IEC 825. Laser Product Label The following label or equivalent is located on the surface of laser products: This label indicates that the product is classified as a CLASS 1 LASER PRODUCT. This label appears on a laser device installed in the product. If you have an LS-120 drive or an LS-260 drive, this label is located next to the Class 1 Laser Product label on the system. Laser Information ● Laser Type: Semiconductor GaAIAs ● Wave Length: 780 +/- 35 nm ● Divergence Angle: 53.5 Degrees +/- 0.5 degrees ● Output Power: Less than 0.2 mW or 10,869 W·m-2 sr-1 ● Polarization: Circular 0.25 ● Numerical Aperture: 0.45 +/- 0.04 Power Supply and Power Cord Set Requirements Power Supply Class I Grounding Requirements For protection from fault currents, the equipment shall be connected to a grounding terminal. Plug the system power cord into an AC outlet that provides a grounded outlet. Substitute cords may not provide adequate fault protection. Only use the power cord supplied with this product or a Hewlett-Packard authorized replacement. Denmark For tilslutning af de øvrige ledere, se medfølgende installationsvejledning. Norway Apparatet må kun tilkoples jordet stikkontakt. 4 Chapter 1 Safety Notices ENWW