HP G50-118NR HP G50 Notebook PC and Compaq Presario CQ50 Notebook PC - Mainten - Page 88
of the fan/heat sink, Remove the fan/heat sink assembly
View all HP G50-118NR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
Remove the fan/heat sink assembly: 1. Disconnect the fan cable from the system board. 2. Turn the system board upside down, with the RJ-11 and RJ-45 jacks toward you. 3. Loosen the four Phillips PM2.0×10.0 captive screws (1) that secure the fan/heat sink assembly to the system board. 4. Remove the fan/heat sink assembly (2) by lifting it straight up. NOTE: The thermal material must be thoroughly cleaned from the surfaces of the fan/heat sink and the system board components each time the fan/heat sink is removed. Thermal grease is located on the section of the fan/heat sink (1) that services the processor (2). Thermal pads are located on the section of the fan/heat sink (3) that services the Northbridge chip (4). Replacement thermal grease and pads are included with all system board, fan/heat sink assembly, and processor spare part kits. 80 Chapter 4 Removal and replacement procedures