HP GbE2c HP GbE2c Ethernet Blade Switch for c-Class BladeSystem Command Refere - Page 9
Command line interface, Introduction, Additional references, Connecting to the switch - user guide
UPC - 808736802215
View all HP GbE2c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Command line interface Introduction The HP GbE2c switch is ready to perform basic switching functions right out of the box. Some of the more advanced features, however, require some administrative configuration before they can be used effectively. This guide provides a command reference for the HP GbE2c Ethernet Blade Switch and the HP GbE2c Layer 2/3 Ethernet Blade Switch. The extensive switching software included in the switch provides a variety of options for accessing and configuring the switch: • Built-in, text-based command line interfaces (AOS CLI and ISCLI) for access via a local terminal or remote Telnet/Secure Shell (SSH) session • Simple Network Management Protocol (SNMP) support for access through network management software such as HP Systems Insight Manager • A browser-based management interface for interactive network access through the Web browser The command line interface provides a direct method for collecting switch information and performing switch configuration. Using a basic terminal, you can view information and statistics about the switch, and perform any necessary configuration. This chapter explains how to access the AOS CLI to the switch. Additional references Additional information about installing and configuring the switch is available in the following guides, which are available at http://www.hp.com/go/bladesystem/documentation. • HP GbE2c Ethernet Blade Switch for c-Class BladeSystem User Guide • HP GbE2c Ethernet Blade Switch for c-Class BladeSystem ISCLI Reference Guide • HP GbE2c Ethernet Blade Switch for c-Class BladeSystem Application Guide • HP GbE2c Ethernet Blade Switch for c-Class BladeSystem Browser-based Interface Reference Guide • HP GbE2c Ethernet Blade Switch for c-Class BladeSystem Quick Setup Instructions Connecting to the switch You can access the command line interface in one of the following ways: • Using a console connection via the console port • Using a Telnet connection over the network • Using a Secure Shell (SSH) connection to securely log in over a network Establishing a console connection To establish a console connection with the switch, you need: • A null modem cable with a female DB-9 connector (See the HP GbE2c Ethernet Blade Switch for c-Class BladeSystem User Guide for more information.) • An ASCII terminal or a computer running terminal emulation software set to the parameters shown in the table below Table 1 Console configuration parameters Parameter Baud Rate Data Bits Parity Stop Bits Flow Control Value 9600 8 None 1 None Command line interface 9