HP Integrity Superdome 2 32-socket Cisco Nexus B22 Fabric Extender for HP Gett - Page 19

Verifying the Configuration Part Revision : Mfg Deviation : H/W Version : 0.0 Mfg Bits : 0 Engineer Use : 0 snmpOID : 0.0.0.0.0.0.0.0 Power Consump : 0 RMA Code : 0-0-0-0 CLEI Code : VID : V00 Supervisor Module specific block: Block Signature : 0x0 Block Version : 0 Block Length : 0 Block Checksum : 0x0 Feature Bits : 0x0 HW Changes Bits : 0x0 Card Index : 0 MAC Addresses : 00-00-00-00-00-00 Number of MACs : 0 Number of EPLD : 0 Port Type-Num : 0-0 Sensor #1 : 0,0 Sensor #2 : 0,0 Sensor #3 : 0,0 Sensor #4 : 0,0 Sensor #5 : 0,0 Sensor #6 : 0,0 Sensor #7 : 0,0 Sensor #8 : 0,0 Max Connector Power: 0 Cooling Requirement: 0 Ambient Temperature: 0 switch(config-fex)# switch(config-fex)# switch(config-fex)# switch(config-fex)# switch(config-fex)# switch(config-fex)# Verifying the Configuration The Onboard Administrator (OA) is the management module used to support and manage the HP BladeSystem c-Class enclosure or the HP Integrity Superdome 2 and all the devices used in the enclosure. Once the switch is installed in the interconnect bay, the OA verifies that the switch type matches the mezzanine cards present on the server blades. If there is no mismatch, the OA powers on the switch. If the switch does not power on, check the enclosure and switch status using the OA web interface. For more information and troubleshooting tips, see the HP BladeSystem Onboard Administrator User Guide or the or the HP Integrity Superdome 2 Onboard Administrator User Guide. To verify the configuration, 1. Locate the LEDs. See Figure 6. Cisco Nexus B22 Fabric Extender for HP Getting Started Guide 19