HP Integrity rx8620 Internal Cabling Guide for HP Smart Array Controllers - Page 32
Folded SCSI Connector
View all HP Integrity rx8620 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
Cabling for the Server Expansion Unit Single Partition RAID Configuration RAID Cabling for IO Chassis 0 (Top Left and Top Right Hot Plug Hard Drives) To set up the RAID cabling on the top left and top right hot plug hard drives, do the following: Step 1. Verify that the HP Smart Array controller card is installed in PCI slot 8 of the IO Chassis 0. Step 2. Retrieve two cables from the cable kit (A7027-63001). Step 3. Identify the new cables using the colored cable ties which are also contained in the cable kit. For each cable, use two of the same color tie, one on each end. NOTE One end of each cable has a pull-tab connected to the SCSI connector which is labeled "This Connector to PCI Card". This end of the cable connects to the HP Smart Array card. Step 4. Plug the end of one of the cables with the pull-tab into the SCSI connector Port 1/A2 on the Smart Array card. Repeat for SCSI connector Port 2 /A1. Step 5. Route the cables as shown in Figure 3-3 towards the front of the server and over to the Mass Storage Backplane connectors. WARNING The cables must be routed along the side of the SEU. They must not lay on top of the flat SCSI ribbon cable bundle or the PCI air dam. Doing so will damage the cables when the top is installed. Step 6. Unplug the existing SCSI ribbon cable for the top left HDD. This is the left most connector on the Mass Storage Backplane when viewed from the front of the server. See Figure 3-1 Step 7. Fold the SCSI connector on the ribbon cable so it will lay in front of the connector on the Mass Storage Backplane. See Figure 3-2. Figure 3-2 Folded SCSI Connector Step 8. Plug the new cable from the Smart Array card Port 1/A2 into the mass storage connector for the top left drive. 28 Chapter 3