HP L1908wm HP L1750, L1950, L1710, L1910, L1908w, L1908wm, L1945w, L1945wv, L2 - Page 24

Removing the Monitor Pedestal Base - wall mount

Get HP L1908wm - 19inch LCD Monitor PDF manuals and user guides
UPC - 883585522804
View all HP L1908wm manuals
Add to My Manuals
Save this manual to your list of manuals

Page 24 highlights

Removing the Monitor Pedestal Base You can remove the monitor panel from the pedestal base to install the panel on a wall, a swing arm, or other mounting fixture. CAUTION: Before beginning to disassemble the monitor, be sure the monitor is turned off and the power and signal cables are both disconnected. If the monitor has a connected audio cable, disconnect it. 1. Disconnect and remove the signal and power cables from the back of the monitor. 2. Lay the monitor face down on a flat surface. 3. Remove the screws on the back of the monitor that connect the monitor panel with the pedestal base. a. On the double-hinged base, there are four screws that connect the monitor panel to the pedestal base. Figure 3-16 Removing the Double-Hinged Pedestal Base 16 Chapter 3 Setting Up the Monitor

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
Removing the Monitor Pedestal Base
You can remove the monitor panel from the pedestal base to install the panel on a wall, a swing arm,
or other mounting fixture.
CAUTION:
Before beginning to disassemble the monitor, be sure the monitor is turned off and the
power and signal cables are both disconnected. If the monitor has a connected audio cable, disconnect
it.
1.
Disconnect and remove the signal and power cables from the back of the monitor.
2.
Lay the monitor face down on a flat surface.
3.
Remove the screws on the back of the monitor that connect the monitor panel with the pedestal
base.
a.
On the double-hinged base, there are four screws that connect the monitor panel to the
pedestal base.
Figure 3-16
Removing the Double-Hinged Pedestal Base
16
Chapter 3
Setting Up the Monitor