HP LH4r HP Netserver LXr Pro8 Memory Board - Page 12

Tools Required, Power-Down Procedure

Get HP LH4r - NetServer - 256 MB RAM PDF manuals and user guides View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals

Page 12 highlights

Chapter 2 Installing Memory in the 4 GB Memory Board Tools Required To remove or install a memory board, first remove the satellite chassis lower fan module and the rear access panel. These tools are required for removal and installation of accessories: • Number 1 Phillips head screwdriver • An anti-static service kit (3M™ 8501/8502/8503 or equivalent). This kit includes a static-dissipating work surface, a chassis clip lead, and a wrist strap. Power-Down Procedure Power to the satellite chassis must be turned off before removing or installing the 4 GB memory boards. 1. Save your existing system configuration. 2. Log off all users, shut down all networking software, applications, and the operating system. 3. Press the DC power switch on the HP NetServer's control panel (Figure 2-4). 8

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
Chapter 2
Installing Memory in the 4 GB Memory Board
8
Tools Required
To remove or install a memory board, first remove the satellite chassis lower fan
module and the rear access panel. These tools are required for removal and
installation of accessories:
•
Number 1 Phillips head screwdriver
•
An anti-static service kit (3M
8501/8502/8503 or equivalent). This kit
includes a static-dissipating work surface, a chassis clip lead, and a wrist
strap.
Power-Down Procedure
Power to the satellite chassis must be turned off before removing or installing the
4 GB memory boards.
1.
Save your existing system configuration.
2.
Log off all users, shut down all networking software, applications, and the
operating system.
3.
Press the DC power switch on the HP NetServer's control panel (Figure
2-4).