HP LaserJet 3200 HP LaserJet 3200 All-in-One Product - (English for Australia) - Page 37
reappears before installation is complete, click, If you are prompted to restart your computer
View all HP LaserJet 3200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Note To install the software for Windows NT 4.0 (direct connect installation with a parallel cable) To install the software on Windows NT 4.0, you must have administrator privileges (on start and restart). w Insert the product software CD-ROM into the CD-ROM drive. x When the welcome screen opens, follow the directions on screen. If the welcome screen does not open, click Start, click Run, type Z:\setup (where Z is the letter of your CDROM disk drive), and then click OK. y Click the button labeled Software Installation. z Continue to step 6 on page 35. Note Note 6 Follow the instructions on the screen to install the software. Before installation is complete, make sure that there is a check mark next to Print a test page (when the prompt appears). In Windows 2000, if the "Found New Hardware Wizard" window reappears before installation is complete, click Cancel. 7 Click Finish. 8 If you are prompted to restart your computer, click Yes. The test page should print after your computer restarts. If you are not prompted to restart your computer, a test page should print immediately. (If you use Windows NT 4.0, you should not have to restart your computer.) 9 Continue to "Check your work #8" on page 36. EN Completing installation 35