HP LaserJet M1319 Service Manual - Page 152
Fuser,
View all HP LaserJet M1319 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 152 highlights
Fuser 1. Remove the following assemblies: ● Scanner assembly. See Scanner assembly on page 85. ● Left cover. See Side covers on page 110. ● Rear cover and fuser cover. See Rear cover and fuser cover on page 113. ● Print-cartridge door. See Print-cartridge door on page 112. ● Front cover. See Front cover on page 115. ● Scanner support-frame and chassis reinforcement plate. See Scanner support-frame on page 124. 2. Disconnect cables from near the top of the engine power assembly and disconnect the large grounding wire from the back of the product. 3. Disengage the wire-harnesses from the wire retainers to release the fuser assembly. 4. Remove three screws (callout 1). NOTE: It is not necessary to remove the delivery-sensor PCA, but you need to move it to gain access to one screw. Figure 6-99 Removing the fuser assembly (1 of 2) 1 134 Chapter 6 Removal and replacement ENWW