HP ML115 Memory technology evolution: an overview of system memory technologie - Page 8
DIMM Configurations, Single-sided and double-sided DIMMs, Single-rank, dual-rank, and quad-rank DIMMs - area code
UPC - 884962252765
View all HP ML115 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
DIMM Configurations Single-sided and double-sided DIMMs Each DRAM chip on a DIMM provides either 4 bits or 8 bits of a 64-bit data word. Chips that provide 4 bits are called x4 (by 4), and chips that provide 8 bits are called x8 (by 8). It takes eight x8 chips or sixteen x4 chips to make a 64-bit word, so at least eight chips are located on one or both sides of a DIMM. However, a standard DIMM has enough room to hold a ninth chip on each side. The ninth chip is used to store 4 bits or 8 bits of Error Correction Code, or ECC (see "Parity and ECC DIMMs" sidebar on next page). An ECC DIMM with all nine DRAM chips on one side is called single-sided, and an ECC DIMM with nine DRAM chips on each side is called double-sided (Figure 7). A single-sided x8 ECC DIMM and a double-sided x4 ECC DIMM each create a single block of 72 bits (64 bits plus 8 ECC bits). In both cases, a single chip-select signal from the chipset is used to activate all the chips on the DIMM. In contrast, a double-sided x8 DIMM (bottom illustration) requires two chip-select signals to access two 72-bit blocks on two sets of DRAM chips. Single-rank, dual-rank, and quad-rank DIMMs In addition to single-sided and double-sided configurations, DIMMs are classified as single-rank or dual-rank. A memory rank is defined as an area or block of 64-bits created by using some or all of the DRAM chips on a DIMM. For an ECC DIMM, a memory rank is a block of 72 data bits (64 bits plus 8 ECC bits). A single-rank ECC DIMM (x4 or x8) uses all of its DRAM chips to create a single block of 72 bits, and all the chips are activated by one chip-select signal from the chipset (top two illustrations in Figure 7). A dual-rank ECC DIMM produces two 72-bit blocks from two sets of DRAM chips on the DIMM, requiring two chip-select signals. The chip-select signals are staggered so that both sets of DRAM chips do not contend for the memory bus at the same time. Quad-rank DIMMs with ECC produces four 72-bit blocks from four sets of DRAM chips on the DIMM, requiring four chip-select signals. Like the dual-rank DIMMs, the memory controller staggers the chip-select signals to prevent the four sets of DRAM chips from contending for the memory bus at the same time. Figure 7. Single-sided and double-sided DDR SDRAM DIMMs and corresponding DIMM rank 8