HP MSA2324i HP StorageWorks 2312/2324 Modular Smart Array controller installat - Page 1
HP MSA2324i Manual
View all HP MSA2324i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
HP StorageWorks 2312/2324 Modular Smart Array controller installation instructions About this document This document describes procedures for installing a controller into an HP StorageWorks 2312/2324 Modular Smart Array. Before you begin CAUTION: When upgrading an existing operational system with a second optional controller, removing the air management blank impacts the airflow and cooling ability of the device. To avoid possible overheating, insert the controller as quickly as possible. If the internal temperature exceeds acceptable limits, the enclosure may overheat and automatically shut down or restart. CAUTION: Parts can be damaged by electrostatic discharge. Use proper anti-static protection. • Keep the replacement component in the ESD bag until needed. • Wear an ESD wrist strap grounded to an unpainted surface of the chassis. • If an ESD wrist strap is unavailable, touch an unpainted surface of the chassis before handling the component. • Never touch connector pins. © Copyright 1999, 2008 Hewlett-Packard Development Company, L.P. First edition: November, 2008 The information in this document is subject to change without notice. Printed in the China www.hp.com Installing a controller (single or dual) for the first time Remove the air management blank(s) NOTE: For clarity, only relevant details are shown in these illustrations. 1. Turn the thumbscrews until the screws disengage from the blank. 1 - Latch 2 - Thumbscrew 2. Press both latches downward. 508933-001 Page 1