HP MSA2324i HP StorageWorks MSA2000 3.5 12-Drive Enclosure I/O module installa - Page 1
HP MSA2324i Manual
View all HP MSA2324i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
HP StorageWorks MSA2000 3.5 12-Drive Enclosure I/O module installation instructions Printed on at least 50% total recycled fiber with at least 10% post-consumer paper © Copyright 2008 Hewlett-Packard Development Company, L.P. Second edition: November, 2008 Product names mentioned herein may be trademarks of their respective companies as reflected by an associated footnote. The information in this document is subject to change without notice. Printed in China. www.hp.com About this document This document describes the procedure for installing an I/O module into an HP StorageWorks MSA2000 3.5 12-drive enclosure. IMPORTANT: Install this module only into an MSA2000 3.5 12-drive enclosure. CAUTION: Parts can be damaged by electrostatic discharge. Use proper anti-static protection. • Keep the replacement component in the ESD bag until needed. • Wear an ESD wrist strap grounded to an unpainted surface of the chassis. • If an ESD wrist strap is unavailable, touch an unpainted surface of the chassis before handling the component. • Never touch connector pins. Removing the air management blank CAUTION: When upgrading an existing operational system with an I/O module, removing the blank impacts the airflow and cooling ability of the device. To avoid possible overheating, insert the I/O module as quickly as possible. If the internal temperature exceeds acceptable limits, the enclosure may overheat and automatically shut down or restart. NOTE: For clarity, only relevant details are shown in these illustrations. 1. Turn the thumbscrews until the screws disengage from the blank. 12 2 1 1 Latch 2 Thumbscrew 2. Press both latches downward. 3. Pull the blank straight out of the enclosure. 481603-002 Page 1