HP Model 748 Installation Guide for Model A4350A Mass Storage Module Upgrade K
HP Model 748 - VME Workstation Manual
 |
View all HP Model 748 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP Model 748 manual content summary:
- HP Model 748 | Installation Guide for Model A4350A Mass Storage Module Upgrade K - Page 1
Installation Guide for Model A4350A Mass Storage Module Upgrade Kit THIS KIT IS TO BE INSTALLED BY QUALIFIED SERVICE PERSONNEL ONLY Workstation Systems Group Order N0. A1658-90673 Edition E0895 Printed in U.S.A. 1 - HP Model 748 | Installation Guide for Model A4350A Mass Storage Module Upgrade K - Page 2
Introduction These instructions document how to install the A4350A upgrade kit in the Model 748i/64 or 748i/100 screw S Bracket Plug S FW Tray Trim and screw S Terminators (SE and FW) S Installation Guide S Wrist Strap S Bag S Static Note S Tie wraps Field Replaceable Units The following are the - HP Model 748 | Installation Guide for Model A4350A Mass Storage Module Upgrade K - Page 3
Wide Differential SCSI Adapter must be installed on the Model 743 CPU board. Refer to the Model A4268A Fast/Wide Differential SCSI Adapter Installation and Service Guide (A4268-90600) for installation instructions. The Operating System must be HP-UX 9.05 or later. Installation Procedures Overview - HP Model 748 | Installation Guide for Model A4350A Mass Storage Module Upgrade K - Page 4
or the rear of the mass storage module. Figure 2 shows the entry of the FW SCSI cable at the rear of the mass storage module (Model 748). Figure 3 shows the entry of the FW SCSI cable at the front of the mass storage module (TELEPACE). 4 - HP Model 748 | Installation Guide for Model A4350A Mass Storage Module Upgrade K - Page 5
Terminator FW Cable SE Cable SE External Connector with Terminator *DDS Tape Drive or Floppy Disk Drive Figure 1 Configurations for the Mass Storage Module in Model with Short Cable FW Cable All devices are mounted in the chassis as shown for the SE Device or FW Drive except for the FW - HP Model 748 | Installation Guide for Model A4350A Mass Storage Module Upgrade K - Page 6
Power Off the System Before performing this upgrade procedure, observe the following precautions: 1. Please refer to your system's Owner's Guide for the procedures to power off the system. 2. Unplug the system unit power cord and the power cords of any peripheral devices from the power - HP Model 748 | Installation Guide for Model A4350A Mass Storage Module Upgrade K - Page 7
Installing Devices in the New Mass Storage Module Follow these steps to install the mass storage devices in the new mass storage module. Figure 4 shows the cabling scheme for the new mass storage module. 1. Remove the mass storage devices from the old mass storage module. 2. Install the mass storage - HP Model 748 | Installation Guide for Model A4350A Mass Storage Module Upgrade K - Page 8
. 5. Slide the new mass storage module into the chassis, secure the screws, and connect the SCSI interface cables. System Verification Please refer to your Owners Guide for information on running the appropriate diagnostics to verify your system's operation. 8
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
 |
 |
1
Installation Guide for Model A4350A
Mass Storage Module Upgrade Kit
THIS KIT IS TO BE INST
ALLED BY QUALIFIED
SER
VICE PERSONNEL ONL
Y
Workstation
Systems Group
Order N0. A1658–90673
Edition E0895
Printed in U.S.A.