HP Nc2400 Multimedia - Windows Vista - Page 8
Removing an optical disc when no computer power is available
UPC - 883585088331
View all HP Nc2400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Removing an optical disc when no computer power is available 1. Insert the end of a paper clip (1) into the release access in the front bezel of the drive. 2. Press in gently on the paper clip until the tray is released, and then pull out the tray (2) until it stops. 3. Remove the disc (3) from the tray by gently pressing down on the spindle while lifting the outer edges of the disc. Hold the disc by the edges and avoid touching the flat surfaces. NOTE If the tray is not fully accessible, tilt the disc carefully as you remove it. 4. Close the media tray and place the disc in a protective case. 4 Chapter 1 Multimedia hardware ENWW
Removing an optical disc when no computer power is available
1.
Insert the end of a paper clip
(1)
into the release access in the front bezel of the drive.
2.
Press in gently on the paper clip until the tray is released, and then pull out the tray
(2)
until it stops.
3.
Remove the disc
(3)
from the tray by gently pressing down on the spindle while lifting the outer
edges of the disc. Hold the disc by the edges and avoid touching the flat surfaces.
NOTE
If the tray is not fully accessible, tilt the disc carefully as you remove it.
4.
Close the media tray and place the disc in a protective case.
4
Chapter 1
Multimedia hardware
ENWW