HP NetServer LT 6000r Installation Guide for Compaq 4000/7000 Racks - Page 11

Installation 3 Installation This section contains detailed instructions for installing an HP NetServer LPr in certain models of Compaq rack enclosures. Preparation Before beginning the installation of the NetServer into the rack, you must prepare the rack and the NetServer. Determine the location at which the NetServer is to be installed in the rack enclosure. Mark the bottom and top of this location on the rack columns. The HP NetServer LPr measures 2 EIA units tall. Marking the Installation Holes First mark one hole on each of the four columns to use for the rack nuts and screws that hold the rail to the column. Then mark two holes on each of the front columns only to use for securing the NetServer to the rack enclosure. When marking the holes, mark the outer surface of the column (see Figure 3-1); on the front columns, this is the column surface facing forward; on the rear columns, this is the surface facing rearward. Use tape or a marker pen to mark the appropriate holes on each column. A rack template which is marked with the appropriate holes is provided with this NetServer. You may use this rack template to show you where to mark the holes on the rack columns, or if you do not wish to use the template, you can simply mark the appropriate holes as indicated in Figure 3-1. To mark the rail mounting holes (refer to Figure 3-1), on each columns, count up from the top of the unit below marking the third hole. 7