Home » HP Manuals » Desktops » HP Pavilion 23-p000 » Manual Viewer

HP Pavilion 23-p000 Hardware Reference Guide - Page 24

HP Pavilion 23-p000 Manual

View all HP Pavilion 23-p000 manuals

Add to My Manuals
Save this manual to your list of manuals

Page 24 highlights

7. Rotate the bottom edge of the access panel up (2), and then lift the access panel off of the computer (3). Figure 3-7 Removing the access panel 8. Place the access panel down on a flat surface with the inside of the panel facing up. 9. Remove the three screws (1) securing the stand to the access panel, and then remove the stand (2). Figure 3-8 Removing the stand NOTE: Save the screws together with the stand in case they are needed in the future. 10. Set the top edge of the access panel down on the top edge of the computer chassis (1). Be sure to align the hooks on the underside of the top edge of the access panel with the top edge of the computer. 11. Rotate the bottom edge of the access panel down (2) and press it firmly onto the chassis until it locks into place. 18 Chapter 3 Hardware repair and upgrade

Section	Page
Product features	7
Overview	7
Front components	9
Side components	10
Rear components	11
Keyboard features	12
Adjusting the stand	13
Waking the computer	13
Serial number location	14
Display options	15
Adjusting the audio signal	15
Adjusting display brightness	15
Hardware repair and upgrade	17
Warnings and cautions	17
Additional information	17
Connecting and disconnecting power	18
Connecting power	18
Disconnecting power	18
Installing a cable lock	19
Installing an access panel security screw	20
Synchronizing the optional wireless keyboard and mouse	21
Removing batteries from the optional wireless keyboard or mouse	22
Attaching the computer to a mounting fixture	23
Connecting a second display	25
Locating internal components	27
Removing and installing memory	27
SODIMMs	27
DDR3-SDRAM SODIMMs	27
Populating SODIMM sockets	29
Installing SODIMMs	29
Replacing the battery	33
Replacing drives	38
Replacing a hard drive	38
Removing a hard drive	38
Removing a 3.5-inch hard drive	38
Removing a 2.5-inch solid state drive (SSD), self-encrypting drive (SED), or solid state hybrid driv ...	41
Installing a hard drive	45
Installing a 3.5-inch hard drive	45
Installing a 2.5-inch solid state drive (SSD), self-encrypting drive (SED), or solid state hybrid dr ...	47
Replacing the optical disc drive	49
Electrostatic discharge	54
Preventing electrostatic damage	54
Grounding methods	54
Computer operating guidelines, routine care, and shipping preparation	55
Computer operating guidelines and routine care	55
Optical disc drive precautions	56
Shipping preparation	56

Match case Limit results 1 per page

Rotate the bottom edge of the access panel up (2), and then lift the access panel off of the

computer (3).

Figure 3-7

Removing the access panel

Place the access panel down on a flat surface with the inside of the panel facing up.

Remove the three screws (1) securing the stand to the access panel, and then remove the stand

(2).

Figure 3-8

Removing the stand

NOTE:

Save the screws together with the stand in case they are needed in the future.

10.

Set the top edge of the access panel down on the top edge of the computer chassis (1). Be sure

to align the hooks on the underside of the top edge of the access panel with the top edge of the

computer.

11.

Rotate the bottom edge of the access panel down (2) and press it firmly onto the chassis until it

locks into place.

Chapter 3

Hardware repair and upgrade