HP Presario 6000 Safety and Regulatory Information Desktops, Thin Clients, and - Page 18

Declaration of Conformity for Products Marked with the FCC Logo (United States only) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. For questions regarding the product, contact: Hewlett-Packard Company P.O. Box 692000, Mail Stop 530113 Houston, Texas 77269-2000 Or, call 1-800-HP-INVENT (1-800-474-6836). For questions regarding this FCC declaration, contact: Hewlett-Packard Company P.O. Box 692000, Mail Stop 510101 Houston, Texas 77269-2000 Or, call (281) 514-3333. To identify this product, refer to the part, series, or model number found on the product. Products with Wireless LAN Devices This product may be equipped with a wireless LAN device. This device must not be co-located or operating in conjunction with any other antenna or transmitter. WARNING! Exposure to Radio Frequency Radiation The radiated output power of this device is below the FCC radio frequency exposure limits. Nevertheless, the device should be used in such a manner that the potential for human contact is minimized during normal operation. During normal operation: To avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antennae should not be less than 20 cm (8 inches), including when the computer display is closed, if integrated into the unit. To identify the location of the wireless antennae, refer to the documentation included with the computer. CAUTION: When using IEEE 802.11a wireless LAN, this product is restricted to indoor use, due to its operation in the 5.15- to 5.25-GHz frequency range. The FCC requires this product to be used indoors for the frequency range of 5.15 GHz to 5.25 GHz to reduce the potential for harmful interference to cochannel mobile satellite systems. High-power radar is allocated as the primary user of the 5.25- to 5.35-GHz and 5.65- to 5.85-GHz bands. These radar stations can cause interference with and/or damage to this device. Australia Telecom Statement The computer must be connected to the Telecommunication Network through a line cord that meets the requirements of ACA Technical Standard TS008. WARNING! Modems without integral RJ-11 that are shipped with this computer must be installed only in devices displaying the A-tick. 12 Chapter 2 Regulatory Agency Notices