HP Presario 6000 Compaq Presario Desktop Products Warranty and Support Guide - Page 11

Regulatory and Safety Information - memory

Get HP Presario 6000 - Desktop PC PDF manuals and user guides View all HP Presario 6000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 11 highlights

Regulatory and Safety Information WARNING: The Compaq Presario is heavy; be sure to use ergonomically correct lifting procedures when moving the computer. WARNING: Electrostatic discharge (ESD) can damage disk drives, add-in cards, and other components. If an ESD station is not available, wear a wrist strap attached to a metal part of the computer. Place cards on a conductive foam pad or inside the conductive wrapper they came in; do not place the cards on top of the wrapper. WARNING: Do not operate the system with the cover removed. Always replace the cover before turning on the system. WARNING: Please read the "Additional Safety Information" located later in this document before installing and connecting your system to the electrical power system. WARNING: Using the wrong type of memory module could damage the system. WARNING: Do not pull the memory module out of the socket. Use the retaining clips to eject the module. WARNING: Do not overload the system by installing add-in cards that draw excessive current. The system is designed to provide 2 amps (average) of +5 V power for each board/card in the computer. The total +5 V current draw in a fully loaded system (one with all add-in card slots filled) must not exceed the total number of slots multiplied by 2 amps. WARNING: Be careful of the sharp edges on the expansion slot cover. WARNING: There is danger of explosion if the battery is incorrectly replaced. Replace only with the same, or equivalent, type of battery. Discard used batteries according to the manufacturer's instructions.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
Regulatory and Safety Information
WARNING:
The Compaq Presario is heavy; be sure to use
ergonomically correct lifting procedures when moving the computer.
WARNING:
Electrostatic discharge (ESD) can damage disk drives,
add-in cards, and other components. If an ESD station is not available,
wear a wrist strap attached to a metal part of the computer. Place cards
on a conductive foam pad or inside the conductive wrapper they came
in; do not place the cards on top of the wrapper.
WARNING:
Do not operate the system with the cover removed.
Always replace the cover before turning on the system.
WARNING:
Please read the “Additional Safety Information” located
later in this document before installing and connecting your system to
the electrical power system.
WARNING:
Using the wrong type of memory module could damage
the system.
WARNING:
Do not pull the memory module out of the socket. Use the
retaining clips to eject the module.
WARNING:
Do not overload the system by installing add-in cards
that draw excessive current. The system is designed to provide 2 amps
(average) of +5 V power for each board/card in the computer. The
total +5 V current draw in a fully loaded system (one with all add-in
card slots filled) must not exceed the total number of slots multiplied
by 2 amps.
WARNING:
Be careful of the sharp edges on the expansion slot cover.
WARNING:
There is danger of explosion if the battery is incorrectly
replaced. Replace only with the same, or equivalent, type of battery.
Discard used batteries according to the manufacturer’s instructions.