HP Presario All-in-One CQ1-2100 Safety and Regulatory Information - Page 10

Power supply and power cord set requirements Power supply class I grounding requirements For protection from fault currents, the equipment shall be connected to a grounding terminal. Plug the system power cord into an AC outlet that provides a ground connection. Substitute cords may not provide adequate fault protection. Only use the power cord supplied with this product or a HewlettPackard authorized replacement. Denmark For tilslutning af de øvrige ledere, se medfølgende installationsvejledning. Finland Laite on liitettävä suojamaadoituskoskettimilla varustettuun pistorasiaan. Norway Apparatet må kun tilkoples jordet stikkontakt. Sweden Apparaten skall anslutas till jordat uttag, när den ansluts till ett nätverk. Power supply requirements The power supplies on some products have external power switches. The voltage select switch feature on the product permits it to operate from any line voltage between 100-127 or 200-240 volts AC. Power supplies on those products that do not have external power switches are equipped with internal circuits that sense the incoming voltage and automatically switch to the proper voltage. For safety reasons, use only the AC adapter provided with the unit or an authorized replacement adapter from Hewlett-Packard. Replacement part numbers may be found at http://www.hp.com/cgibin/hpsupport/index.pl. For use in Norway This product is also designed for an IT power system with phase-to-phase voltage 230V. Power cord set requirements The power cord set received with the product meets the requirements for use in the country where the equipment was originally purchased. Use only the power cord provided with the unit or an authorized replacement power cord from Hewlett-Packard or an approved HP source. Replacement part numbers may be found at http://www.hp.com/cgi-bin/hpsupport/index.pl. 4 Chapter 1 Safety notices