HP Presario CQ36-100 Compaq Presario CQ35 and CQ36 Notebook PC - Maintenance a - Page 71
to which the keyboard cable is attached, and then, Release the zero insertion force ZIF connector
View all HP Presario CQ36-100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
Removal and replacement procedures 2. Turn the computer display-side up with the front toward you. 3. Open the computer as far as possible. 4. Lift the rear edge 1 of the keyboard until it rests at an angle. 5. Slide the keyboard 2 toward the display until the tabs on the front edge of the keyboard are clear of the openings in the top cover. 6. Swing the rear edge of the keyboard 3 up and forward until it rests upside down on the top cover. 7. Release the zero insertion force (ZIF) connector 1 to which the keyboard cable is attached, and then disconnect the keyboard cable 2 from the system board. 8. Remove the keyboard. Reverse this procedure to install the keyboard. 4-23
Removal and replacement procedures
4–23
2. Turn the computer display-side up with the front toward you.
3. Open the computer as far as possible.
4. Lift the rear edge
1
of the keyboard until it rests at an angle.
5. Slide the keyboard
2
toward the display until the tabs on the front edge of the keyboard are clear of the
openings in the top cover.
6. Swing the rear edge of the keyboard
3
up and forward until it rests upside down on the top cover.
7. Release the zero insertion force (ZIF) connector
1
to which the keyboard cable is attached, and then
disconnect the keyboard cable
2
from the system board.
8. Remove the keyboard.
Reverse this procedure to install the keyboard.