HP ProDesk 600 Hardware Reference Guide - Page 89
Reconnect the power cord and turn on the computer., If the computer was on a stand, replace the stand.
View all HP ProDesk 600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
11. Connect the power cable (1) and data cable (2) to the back of the hard drive. NOTE: The data cable for the primary hard drive must be connected to the dark blue connector labeled SATA0 on the system board to avoid any hard drive performance problems. 12. Replace the access panel. 13. If the computer was on a stand, replace the stand. 14. Reconnect the power cord and turn on the computer. 15. Lock any security devices that were disengaged when the access panel was removed. ENWW Installing and removing drives 81
11.
Connect the power cable (1) and data cable (2) to the back of the hard drive.
NOTE:
The data cable for the primary hard drive must be connected to the dark blue connector
labeled SATA0 on the system board to avoid any hard drive performance problems.
12.
Replace the access panel.
13.
If the computer was on a stand, replace the stand.
14.
Reconnect the power cord and turn on the computer.
15.
Lock any security devices that were disengaged when the access panel was removed.
ENWW
Installing and removing drives
81