HP ProLiant xw2x220c Hardware and Software Supported by HP ProLiant Blade Work - Page 11
Hardware supported with the blade workstations, Enclosures, storage blades and interconnect modules
View all HP ProLiant xw2x220c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
3 Hardware supported with the blade workstations This chapter lists the hardware that is supported with the blade workstation, including hardware external and internal to the blade workstation. 3-1 Enclosures, storage blades and interconnect modules Support of the following hardware components on the two blade workstations is independent of the operating system installed on the blade workstations. Table 3-1 Enclosures, storage blades, and network interconnect modules supported by the blade workstations Component xw460c xw2x220c Comment Enclosures c3000 enclosure 3 c7000 enclosure 3 Partner blades HP Graphics Expansion Blade 3 SB40c Storage blade 3 3 Accommodates up to 8 blades. The c3000 enclosure is available in both rack and tower models. 3 Accommodates up to 16 blades. Interconnect Modules that interface to NIC1 and NIC2 of the blade workstation HP BL c-Class Ethernet Pass 3 Through Module HP BL c-Class Cisco Catalyst 3 Blade Switch 3020 HP BL c-Class Cisco Catalyst 3 Blade Switch 3120 HP BL c-Class GbE2C Ethernet 3 Blade Switch HP BL c-Class GbE2c Layer 2/3 3 Ethernet Blade Switch HP BL c-Class 1:10Gb Ethernet 3 BL-c Switch HP 1/10G Virtual Connect 3 Ethernet Module 3 3 NOTES: 3 1. The two built-in network interfaces, NIC1 and NIC2, on the blade workstation are pre-set to operate at 1 Gb/s, and cannot be set to other data rates. Therefore, the HP 3 BL c-Class Ethernet Pass Through Module requires connection to a 1 Gb/s network, and does not support connection to 10/100 Mb/s networks. 3 2. For information on HP BladeSystem interconnect modules, visit 3 www.hp.com/go/bladesystem/interconnects. 3 Interconnect Modules that interface to a Mezzanine 1 Fibre Channel card, if installed HP 16 port 4Gb Fibre Channel Pass-Thru Module 3 Brocade 4Gb SAN Switch 3 Cisco MDS 9124e Fabric Switch 3 HP 4Gb Virtual Connect Fibre Channel Module 3 NOTES: 1. For information on the supported Fibre Channel cards, see Table 3-6. 2. For information on HP BladeSystem interconnect modules, visit www.hp.com/go/bladesystem/interconnects. Hardware supported with the blade workstations 11