HP ScanJet Pro 3500 Warranty and Legal Guide - Page 39
Eurasian Conformity (Belarus, Kazakhstan, Russia), Important safety instructions
View all HP ScanJet Pro 3500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Eurasian Conformity (Belarus, Kazakhstan, Russia) Important safety instructions Read all these instructions, and follow all instructions and warnings marked on the scanner. ● In this document, warnings, cautions and notes indicate the following: - Warnings must be followed carefully to avoid bodily injury. - Cautions must be observed to avoid damage to your equipment. - Notes contain important information and useful tips on the operation of this product.. ● Place the scanner close enough to the computer for the interface cable to reach it easily. Do not place or store the device or its AC adapter: - Outdoors - Near excessive dirt or dust, water, or heat sources - In locations subject to shocks, vibrations, high temperature or humidity, direct sunlight, strong light sources, or rapid changes in temperature or humidity Do not use the device with wet hands. ● Place the scanner and its AC adapter near an electrical outlet where the AC adapter can easily be unplugged. CAUTION: Be sure the AC power cord meets the relevant local safety standards. ● Position the AC power cord in such a way to avoid abrasions, cuts, fraying, crimping, and kinking. Do not place objects on top of the AC power cord, and do not allow the AC adapter or the AC power cord to be stepped on or run over. Be particularly careful to keep the AC power cords straight at the ends, and at the point where they enter the AC adapter. ● The AC adapter is designed for use with the scanner with which it was included. Do not attempt to use it with other electronic devices unless specified. ● Use only the type of power source indicated on the product's label. ● When connecting this product to a computer or other device with a cable, ensure the correct orientation of the connectors. Each connector has only one correct orientation. Inserting a connector in the wrong orientation may damage both devices connected by the cable. ● Avoid using outlets on the same circuit as photocopiers or air control systems that regularly switch on and off. ● If you use an extension cord with the scanner, make sure the total ampere rating of the devices plugged into the extension cord does not exceed the cord's ampere rating. Also, make sure the total ampere rating of all devices plugged into the wall outlet does not exceed the wall outlet's ampere rating. ENWW Eurasian Conformity (Belarus, Kazakhstan, Russia) 35