HP Scitex FB700 HP Scitex FB500 and FB700 Printer Series - User Cleaning Instr - Page 29

Clean the media thickness sensor roller quarterly, Proceed

Get HP Scitex FB700 PDF manuals and user guides View all HP Scitex FB700 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 29 highlights

4. Turn the spigot (A in the photo below) to the open position 5. After the waste ink has drained, turn the spigot to the closed position CAUTION: The drain spigot must remain closed during printing and service station use. An open spigot affects the vacuum level in the service station and will degrade service station performance if left open. 6. To reset the maintenance counter for this task and complete the procedure, press Proceed. Clean the media thickness sensor roller (quarterly) The media thickness sensor is located on the carriage rail, on the user end. Debris on the media thickness sensor roller can result in inaccurate measurements. Clean the roller to keep the sensor operating correctly. NOTE: Users of printers in California must disregard all references to the Printhead Flush or IPA in the instructions or when displayed on the control panel. Instead, the alternative cleaning liquid specified at the beginning of this section must be used. 1. From the control panel (System page > Tools > User Cleaning and Maintenance), select Clean Media Thickness Sensor Roller. 2. Press Proceed to continue. ENWW Clean the media thickness sensor roller (quarterly) 27

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
4.
Turn the spigot (A in the photo below) to the open position
5.
After the waste ink has drained, turn the spigot to the closed position
CAUTION:
The drain spigot must remain closed during printing and service station use. An
open spigot affects the vacuum level in the service station and will degrade service station
performance if left open.
6.
To reset the maintenance counter for this task and complete the procedure, press
Proceed
.
Clean the media thickness sensor roller (quarterly)
The media thickness sensor is located on the carriage rail, on the user end. Debris on the media
thickness sensor roller can result in inaccurate measurements. Clean the roller to keep the sensor
operating correctly.
NOTE:
Users of printers in California must disregard all references to the Printhead Flush or IPA in
the instructions or when displayed on the control panel. Instead, the alternative cleaning liquid
specified at the beginning of this section must be used.
1.
From the control panel (
System page > Tools > User Cleaning and Maintenance
), select
Clean Media Thickness Sensor Roller
.
2.
Press
Proceed
to continue.
ENWW
Clean the media thickness sensor roller (quarterly)
27