HP Server rp2470 rp24xx A180 User Manual - Page 74
Status, Definition, CM>, ser cc, Service Menu: Enter command > cc, CHASSIS CODES INFORMATION
View all HP Server rp2470 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
A-Class System Service A-Class Server Trouble Shooting The HSC Remote Management card shows status information on the console just above the function key display (shown above) and is followed by the CM> prompt. The information displayed is shown below: OSTAT Chassis Code REMOTE stat activit password ACCESS FAULT: : us y CM> HSC Remote Management status information is defined as follows: Status Code Definition OSTAT Chassis REMOTE: ACCESS FAULT: Operating STATus. Values can be OFF, FLT, TEST, INIT, SHUT, WARN RUN and ALL. A four digit field used in conjunction with OSTAT to identify system status. The first digit of a chassis code is the Major Code Category value. REMOTE modem port. Three fields describe the Remote modem port. • enabled/disabled: Remote modem port is connected or not connected. • active/inactive: Remote modem port is working or idle. • single/multiple: Number of attempts to enter the password. Number of failed attempts to access the HSC Remote Management Card. For more information on the HSC Remote Management card, refer to the HSC Remote Management/Access Port Card information in the Reference section. During selftest, OSTAT and chassis codes are generated and stored by the server firmware. These chassis codes can be viewed even if an HSC Remote Management card is not installed. To view power on chassis codes, either type ser cc at the firmware main menu, or change to the Service Menu and type cc. A display of OSTAT and chassis codes are shown in the following example: Chassis codes used in conjunction with the OSTAT value represent the status of the system: Service Menu: Enter command > cc CHASSIS CODES INFORMATION Chassis Code 74 Chapter 3