HP StorageWorks 2/32 HP StorageWorks Fabric OS 5.3.1b release notes (5697-7644 - Page 23
Fabric OS 5.3.0b, Fabric OS 5.3.0c - storageworks edge switch
View all HP StorageWorks 2/32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Fabric OS 5.3.0b fixes Table 5 lists defects closed in the Fabric OS 5.3.0b firmware release. Table 5 Fabric OS 5.3.0b closed defects Closed defect summary Solution With FC Tape Pipelining enabled on a 400 MP Router/MP Router Blade FCIP connection, data written to tape using a block size of greater than 128 KB will not be readable by some applications, causing backup to be unreadable. Backup application could be configured to use less than 128 KB block size to avoid the problem, but this is now fixed in 5.3.0b. In rare cases, CRC errors can occur on Brocade 4Gb SAN Switch for Fabric OS 5.3.0b addresses this HP c-Class BladeSystem internal ports when operating at 4Gb/s. issue. When supportsave is run in a continuous loop, certain types of files are not detected which periodically generates the message: SupportSave completed sh: /tmp/supportSave_files/CONSOLE0: No such file or directory. File name can vary. Fixed in Fabric OS 5.3.0b. When the SFP/XFP power and voltage readings are above or below the range, an excessive number of alert messages were reported. Fixed in Fabric OS 5.3.0b. Third-party application will not work with the 400 MP Router Fast Write application (sends FCP_RSP without sequence initiative). Fixed in Fabric OS 5.3.0b. On the B-Series MP Router Blade or 400 MP Router, the proxy PID is improperly converted to 000000 for an ACC to a REC extended link request when an EX_Port is configured for interop mode. As a result, Tape backup may not work with devices in McDATA edge fabrics across the Router due to an improper response to a REC extended link request to a tape device. Fixed in Fabric OS 5.3.0b. Fabric OS 5.3.0c fixes Table 6 lists defects closed in the Fabric OS 5.3.0c firmware release. Table 6 Fabric OS 5.3.0c closed defects Closed defect summary Solution I/O Ops failure due to incorrect CUP Port PDCM bit for port 256 after firmwareupgrade from FOS 5.1.x to FOS 5.2.x/5.3.x in FICON Fixed in Fabric OS 5.3.0c. environment. With McDATA edge switches in the fabric, 400 MP Router or FR4-18i router port receives periodic RRQ & ABTS frames due to the McDATA switch sending unsupported CT command. Routers don't respond, which causes McDATA switch to retry indefinitely. Fixed in Fabric OS 5.3.0c to reject the unsupported CT command. After switchdisable & switchenable, all 400 MP Routers or FR4-18i routers, proxydevices and nameserver entries no longer match what was previously recorded. "fcrrproxydevshow -a" shows 0 devices and translate domains are missing from the edge fabric. This is due to a timing issue while in open fabric interop mode with i10k switch when 2nd IFL is connected to the same switch in the fabric as the 1st IFL, and 1st IFL is fully up. Fixed in Fabric OS 5.3.0c. Hosts lose paths to targets due to FCR daemon failing to send GA_NXT response from 400 MP Router to host connecting to McDATA switch in open fabric mode. Caused by incorrect domain offset in its address translation. Fixed in Fabric OS 5.3.0c. HP StorageWorks Fabric OS 5.3.1b release notes 23