HP StorageWorks 2/32 HP StorageWorks Fabric OS 5.3.2c release notes (5697-0150 - Page 14
Fixed in Fabric OS 5.3.1., When PID-2 change occurs, WebTools incorrectly translates the PID format
View all HP StorageWorks 2/32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Backbone to edge traffic across FCIP links and ISLs may not be evenly distributed across all possible routes (edge to backbone and backbone to edge). Fixed in Fabric OS 5.3.1. When disabling an NPIV switch which has an Access Gateway connected to it, the F_Ports that failover to the other NPIV switch show as No device Fixed in Fabric OS 5.3.1. found when running nszonemember for these F_Ports. When perfMonitorShow -class ISL 0 command is run, some switches give incorrect output as follows: The number of destination Fixed in Fabric OS 5.3.1. domains monitored is set to zero. Unexpected switch reboot may occur during hafailover. During an upgrade, rcsd may get into an infinite loop and block RCS from completing a sync dump, leaving RCS transaction hanging. Switch panic may occur and traffic may be interrupted. Fixed in Fabric OS 5.3.1. Flooding of an unknown interswitch FDMI command from non-Brocade switch causes daemon to be killed due to out of memory condition, causing Fixed in Fabric OS 5.3.1. the switch to crash. Linux kernel issue may occur on 2Gb switches running Fabric OS 5.3.0x caused by service daemon thread (fwd, nsd, fabricd) becoming unresponsive due to deadlock condition. This can trigger a panic, or snmpd hang. Fixed in Fabric OS 5.3.1. Fabric OS crash occasionally seen when Access Gateway enabled switch is rebooted with large number of Access Gateway devices in the fabric. Fixed in Fabric OS 5.3.1. During fastwrite, specific third party device drops a frame that is not 8 byte aligned. Fixed in Fabric OS 5.3.1. With 2-GB switches, hafailover under heavy load across ISLs, followed by portdisable/portenable of E-ports causes port blade fault with tx Fixed in Fabric OS 5.3.1. parity error (error 21). When PID-2 change occurs, WebTools incorrectly translates the PID format in the NameServer and displays an incorrect account of the area/ports contained in a zone or alias member list. This can also happen when attempting to add to a zone or alias list, causing an incorrect physical port to be added. Fixed in Fabric OS 5.3.1. During stress test with 2Gb switch, when receive buffer overflow occurs, third party device port is stuck in offline state for more than 30 seconds. Portdisable/portenable will recover the port. Fixed in Fabric OS 5.3.1. Intermittent supportsave failure messages seen during sup-portsave loop. Fixed in Fabric OS 5.3.1. Traffic stops during FCIP testing with Tape Pipelining enabled, when host floods the switch with Name Server query. This occurs because the query response is not passed back to the host on the backbone switch through the FCR router. Fixed in Fabric OS 5.3.1. When executing fastwrite with Tape Pipelining with a slow responding tape device, the switch sent improper frame causing tape job to fail. Ulti- Fixed in Fabric OS 5.3.1. mately, this caused the initiator to lose access to the tape drive. 14