HP StorageWorks 2/32 HP StorageWorks SAN Switch Rack Mount Kit Installation In - Page 19
Tighten the hex nuts installed in, on See, This completes the rack mount procedure., step 4
View all HP StorageWorks 2/32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Figure 10: Securing the Device (in an HP System/e rack) 3. Tighten the hex nuts installed in step 4 on page 10. See Figure 3. Note: To uninstall a device, remove the middle #10-32 x 1/2-inch Phillips pan head screw with captive star lock washer from either side of the rack uprights. This completes the rack mount procedure. SAN Switch rack mount kit installation instructions 19
19
SAN Switch rack mount kit installation instructions
Figure 10:
Securing the Device (in an HP System/e rack)
3.
Tighten the hex nuts installed in
step 4
on page 10. See
Figure 3
.
Note:
To uninstall a device, remove the middle #10-32 x 1/2-inch Phillips pan head
screw with captive star lock washer from either side of the rack uprights.
This completes the rack mount procedure.