HP StorageWorks 2/32 SAN switch rack mount kit installation instructions - Page 16
Assemble the two inner rails one on each side to the switch using the, appropriate number from, of #
View all HP StorageWorks 2/32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
a. Assemble the two inner rails (one on each side) to the switch using the appropriate number (from step 5) of #8-32 x 3/16-inch Phillips pan-head screws as shown in Figure 7. Note: The rail kit provides fourteen #8-32 x 3/16-inch screws for assembling the inner rails. Each switch requires a different number of these screws. For example, Figure 7 shows the an inner rail being attached to the SAN Switch 2/16 with five screws. Attaching both inner rails requires ten screws. Figure 7: Assembling the inner rails Note: For factory integration only, tighten the #8-32 x 3/16-inch Phillips pan-head screw with thread lock and torque between 6 to 8 inch-pounds. 16 SAN Switch Rack Mount Kit Installation Instructions
16
SAN Switch Rack Mount Kit Installation Instructions
a.
Assemble the two inner rails (one on each side) to the switch using the
appropriate number (from
step 5
) of #8-32 x 3/16-inch Phillips pan-head
screws as shown in
Figure 7
.
Note:
The rail kit provides fourteen #8-32 x 3/16-inch screws for assembling the inner
rails. Each switch requires a different number of these screws. For example,
Figure 7
shows the an inner rail being attached to the SAN Switch 2/16 with five screws.
Attaching both inner rails requires ten screws.
Figure 7:
Assembling the inner rails
Note:
For factory integration only, tighten the #8-32 x 3/16-inch Phillips pan-head
screw with thread lock and torque between 6 to 8 inch-pounds.