HP StorageWorks 4/16 Brocade Fabric OS MIB Reference Guide v6.2.0 (53-1001156- - Page 27
Brocade 7500 / FR4-18i and Brocade MIBs, Access Gateway and Brocade MIBs, Firmware Upgrades
View all HP StorageWorks 4/16 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Brocade 7500 / FR4-18i and Brocade MIBs 1 Brocade 7500 / FR4-18i and Brocade MIBs Beginning with release Fabric OS 5.3.0, statistics are available for FCIP tunnels, VEX_Ports, or VE_Ports through the portstatsshow command. The changes in the sensor details for FR4-18i Blade has been incorporated into SNMP. The "connUnitSensorTable 1.3.6.1.3.94.1.8" on page 920 and "swSensorTable 1.3.6.1.4.1.1588.2.1.1.1.1.22" on page 552 display information consistent with the Fabric OS sensorShow command. Access Gateway and Brocade MIBs Brocade Access Gateway supports the following MIBs. TABLE 3 Access Gateway MIB Support MIB Name Supported Description MIB-2 Entity-MIB HA MIB SW-MIB FA-MIB FE-MIB CPQ-Rack MIB FCIP MIB iSCSI MIB Yes Yes Yes No Yes No Limited Limited Limited Updated to support Access Gateway in v5.2.1. Disabled in Access Gateway because the conventions are specific to fabric switches. The connUnitSnsTable is not supported because a switch in Access Gateway does support name server services. Disabled in Access Gateway because the conventions are specific to fabric switches. Supported on embedded switches only. Implemented to support WAN interfaces in Fabric OS v5.3.0 Supports displaying information about virtual targets (VTs), iSCSI sessions, and TCP connection tables, as derived from specific MIB tables Firmware Upgrades and Enabled Traps Prior to Fabric OS v4.4, traps were turned on and off as a group (for example, the SW-Trap, or FA-Trap). In these versions of the Fabric OS it was not possible to set individual traps (such as, swSensorStatusChangeTrap, swTrackChangesTrap, or connUnitEventTrap). In Fabric OS v4.4 or above you can to turn on and off traps individually within a trap group. After the trap group is enabled, the individual traps need to be enabled explicitly. Because the pre- Fabric OS v4.4 firmware only has trap group level settings, when you upgrade to the Fabric OS v4.4 firmware or above, individual traps are turned off by default even if the corresponding trap group was enabled before upgrading. When moving from a downlevel version to Fabric OS v4.4 or above you must use the snmpconfig command to turn on explicitly the individual traps within each trap group. Fabric OS MIB Reference 11 53-1001156-01