HP StorageWorks 4/8 Brocade Error Message Reference Guide v6.0.0 (53-1000600-0 - Page 294

29 FW-1434 FW-1434 Message , [FW-1434], ,, WARNING, , Switch status change contributing factor Blade: blade failures. Probable Cause Indicates that the switch status is not in a healthy state. This occurred because the number of blade failures is greater than or equal to the policy set by the switchStatusPolicySet command. Recommended Replace the faulty blade. Action Severity WARNING FW-1435 Message , [FW-1435], ,, WARNING, , Switch status change contributing factor Flash: usage out of range. Probable Cause Indicates that the switch status is not in a healthy state. This occurred because the flash usage is out of range. The policy was set using the switchStatusPolicySet command. Recommended Run the supportSave command to clear out the kernel flash. Refer to the Fabric OS Command Action Reference for more information about this command. Severity WARNING FW-1436 Message , [FW-1436], ,, WARNING, , Switch status change contributing factor Marginal ports: marginal ports. (Port(s) ) Probable Cause Indicates that the switch status is not in a healthy state. This occurred because the number of marginal ports is greater than or equal to the policy set using the switchStatusPolicySet command. A port is faulty when the port value for Link Loss, Synchronization Loss, Signal Loss, Invalid word, Protocol error, cyclic redundancy check (CRC) error, Port state change or Buffer Limited Port is above the high boundary. Recommended Replace any faulty or deteriorating small form-factor pluggables (SFPs). Action Severity WARNING 242 Fabric OS Message Reference 53-1000600-01