HP StorageWorks 4/8 HP StorageWorks Fabric OS 6.1.0h release notes (5697-7961, - Page 20

Closed defect summary Solution If a device tries to login to an NPIV port using a port WWN, which is already used by another device that has already logged in, the switch simply drops the new login (FDISC) request instead of rejecting it. Fixed in Fabric OS 6.1.0 Incorrect FRU Update date is received for Brocade_Chassis class. Fixed in Fabric OS 6.1.0 SetInstance call is failing for Brocade_Switch class. Fixed in Fabric OS 6.1.0 Problem attempting to lock a port as an L_Port and configure the duplex Fixed in Fabric OS 6.1.0 mode using the CLI. Inconsistent support for switch service tag between CLI and Web Tools. Fixed in Fabric OS 6.1.0 Port_scn removes logical paths from wrong port. Fixed in Fabric OS 6.1.0 IOCTL not allowed: cmd 0x40040911, pid 11347 (ficonshow) message seen on the console. Fixed in Fabric OS 6.1.0 Validation of IP address to SetProperty/SetInstance for CommunityInfoSet on Brocade_Switch class is not present on higher version (5.3,6.0). Fixed in Fabric OS 6.1.0 nsd killed during overnight iSCSI blade slotpoweroff/on testing. Fixed in Fabric OS 6.1.0 bladebeacon command should fail for core blades and switchshow Fixed in Fabric OS 6.1.0 command should not show beacon status for core blades in the DC Director chassis. Even after deleting enabled DDset the DD members of that particular Fixed in Fabric OS 6.1.0 ddset are still shown as enabled. frureplace wwn command for DC Director platform takes over ten Fixed in Fabric OS 6.1.0 minutes to complete. Web Tools - USB admin always displays firmware build size incorrectly Fixed in Fabric OS 6.1.0 as 32768 bytes whereas CLI shows the actual size. CRC errors mismatch between porterrshow and portstatsshow Fixed in Fabric OS 6.1.0 output. Upon repeated reboots of the MP Router switch, ExternalInput Oops message seen on the console, (stress-to-fail test). Fixed in Fabric OS 6.1.0 FCIP testing with tape pipelining enabled results in failures. Fixed in Fabric OS 6.1.0 Shortly after cfgdisable on an edge 4/256 SAN Director, got a raslogd core dump. Fixed in Fabric OS 6.1.0 Changing desired distance by issuing "portcfglongdistance ,slot/port> 1d 1 " from lower WWN switch often causes E_Port to stuck at Unknown or send ECP failed and disabled. Fixed in Fabric OS 6.1.0 With EX_Pports configured observed VERIFY on performing hafailover - Failed expression: 0, c2_debug.c, line = 7896 Call back trace:Trace: bfe4241c when EX_Ports exist. Fixed in Fabric OS 6.1.0 20