HP StorageWorks 8/80 Brocade Fabric OS Administrator's Guide v6.3.0 (53-100133 - Page 389

Admin Domain management for physical fabric administrators 15 where: source_AD source_name dest_name Name of the user-defined AD from which you are copying the zone. Name of the zone to be copied. Name to give the zone after it is copied to AD0. 4. Copy the newly added zones in AD0 to the zone configuration. cfgadd "cfgName", "member[;member]" 5. Enable the configuration to complete the transaction. cfgenable cfgName 6. Switch to the AD255 context. ad --select 255 7. Explicitly add devices that are present in the user-defined ADs to AD0. ad --add AD0 -d "dev_list" 8. Enter the ad --apply command to save the Admin Domain definition and directly apply the definitions to the fabric. ad --apply At this point, all of the devices in the user-defined ADs are also defined and zoned in AD0. 9. Clear the user-defined ADs. ad --clear -f 10. Enter the ad --apply command to save the Admin Domain definition and directly apply the definitions to the fabric. ad --apply All user-defined Admin Domains have now been removed, but all device communication that was allowed with the original Admin Domain configuration is still permitted in the context of AD0. Example The following example assumes the configuration shown in Figure 44: • Three Admin Domains: AD0, plus two user-defined Admin Domains (AD1 and AD2) • AD0 has two devices, WWN1 and WWN2, in the AD0_RedZone • AD1 has two devices, WWN2 and WWN3, in the AD1_BlueZone • AD2 has two devices, WWN3 and WWN4, in the AD2_GreenZone • The device WWN2 is in both AD0 and AD1. At the conclusion of the procedure, all devices and zones are moved to AD0, and the user-defined Admin Domains are deleted, as shown in Figure 45. Fabric OS Administrator's Guide 347 53-1001336-01