HP StorageWorks 8/80 Brocade Fabric OS MIB Reference v6.3.0 (53-1001339-01, Ju - Page 241

connUnitControl 1.3.6.1.3.94.1.6.1.22 8 For a fabric switch set to sysDescr and read-only. For a Brocade Access Gateway device set to "Access Gateway." connUnitControl 1.3.6.1.3.94.1.6.1.22 Controls the addressed connUnit. Each implementation might choose not to allow any or all of these values on a SET. Cold start and warm start are as defined in MIB-II and are not meant to be a factory reset. This is similar to swAdmStatus: resetConnunitColdStart = reboot resetConnunitWarmStart = fastboot offlineConnUnit = disable switch onlineConnUnit = enable switch default after reboot = unknown The declaration 1 (unknown) maps to the default value upon rebooting, and 2 (invalid) is not applicable. Declarations 3 and 4 perform the same operation-a cold boot of the switch. Values Possible values are: • unknown (1) • invalid (2) • resetConnUnitColdStart (3): Reboot. Performs a switch reboot. • resetConnUnitWarmStart (4): Fastboot. The addressed unit performs a Warm Start reset. • offlineConnUnit (5): Disable switch. The addressed unit puts itself into an implementation-dependant offline state. In general, if a unit is in an offline state, it cannot be used to perform meaningful Fibre Channel work. • onlineConnUnit (6): Enable switch. The addressed unit puts itself into an implementation-dependant online state. In general, if a unit is in an online state, it is capable of performing meaningful Fibre Channel work. connUnitContact 1.3.6.1.3.94.1.6.1.23 Contact information for this connectivity unit. Displays the same value as sysContact. Changing the value in this variable causes the value in sysContact to also be changed. connUnitLocation 1.3.6.1.3.94.1.6.1.24 Location information for this connectivity unit. Displays the same value as sysLocation. Fabric OS MIB Reference 223 53-1001339-01