HP Tc2100 ReadFirst sheet for hp tower server tc2100 (English) - Page 3

ReadFirst Sheet for HP Tower Server tc2100 6d) Add PCI Accessory Boards l You can install additional accessory boards, but don't install third party boards until you have verified the Server's operations. l The addition of a disk drive controller board, when not shipped with the Server from the factory, may affect boot order and prevent you from successfully verifying the Server's operation. For details refer to Chapter 6, "Installing Additional Boards" in the HP Server tc2100 Installation Guide. 6e) Replace the covers l Ensure all cables are properly routed and all components are fully seated, before replacing covers. For details refer to Chapter 3, "Opening and Closing the HP Server" in the HP Server tc2100 Installation Guide. Applying Power to the Server 7) Check/Set the Power Supply Input Voltage l Check the input voltage switch on the power supply located at the rear of the Server below the power connector, as shown below. The input voltage switch has two positions: 115 or 230 volts - 230 volts is the default position. CAUTION To prevent damage to the power supply, set the input voltage switch on the power supply to the correct input line voltage before connecting the power cord to an AC voltage source. Power Connector (Switch shown in 115 volts position.) Input Voltage Switch HP Part Number P4648-90004, Doc # P4648-90004-1 Printed in August 2001 '!#!%(& !'